Passive Fire Protection
When you have unsealed openings in a building’s fire walls and floors, they cancel out the fire resistance ratings of the fire separations. This means flames can spread past the limits…
Mechanical, electrical and structural components often need to pass through Fire Rated walls and floors. They’re installed in carefully planned, strategically positioned openings…
Linear Gap Seals are a range of Fire Proof Systems used to seal technological gaps within the fabric of the building. They are designed to stop the spread of fire while allowing the structure…
Movement Joints Fire Seals are a type of Linear Fire seals for which ADEPT CONTRACTS LTD provides a full range of systems from the leading Passive Fire Protection manufacturers to meet…
Fire Rated Sleeves are designed to prevent the spread of fire and smoke through plastic pipes which penetrate fire compartment walls and floors by filling the void created when the heat…
Fire Rated Sleeves are designed to prevent the spread of fire and smoke through plastic pipes which penetrate fire compartment walls and floors by filling the void created when…
Where fire-resistance-rated floor or floor ceiling assemblies are required the unprotected void at the edge of slab becomes a chimney or flue for fire to rage up the inside of the building…
Horizontal and vertical sealed spaces often need to incorporate compartments, also called cavity barriers. These are used to slow the spread of heat, smoke and fire. They are…
Cavity Barriers should not be mistaken with Fire Barriers. They are designed to reduce the spread of fire and smoke specifically in the ceiling void and can’t be used for maintaining compartmentation…
Where fire resistance-rated floor or floor ceiling assemblies are required where the unprotected void at the edge of slab becomes a chimney or flue for fire to rage up the inside of…
Our rain screen cavity barriers are tested in accordance with BS EN:1363-1:1999 our systems have proved to provide up to 2 hours fire protection and offer a free cavity behind…
Structural steel fire protection systems are either reactive or non-reactive systems, most commonly boards, sprays and thin film-like intumescent coatings. The non-reactive type is…
Ductwork systems pass through different compartments within the building structure and can take many shapes and sizes making it hard to establish the most cost effective Fire Proofing System…
Fire Protection Rigid Board Systems or “Heavy weight” (750kg/m3-950kg/m3) boards usually take decorative finishes and are used in areas where aesthetics are important and they can…
We specialise in design and installation of high impact, heavy duty Fire Rated partitions and ceilings. These are for EDF Rooms, Switch Rooms, Tank Rooms, Substations, Electrical…
Timber floors must be inspected and tested in accordance with BS 476: Part 21: 1987 on the criteria of load bearing integrity and insulation in a case of fire from below…
Rainscreen Cavity Fire Barriers developed to provide horizontal fire stopping for a variety of Rainscreen Cladding Systems. Tested in accordance with BS EN:1363-1:1999 our systems…